The CLA7v2 generates an induction (loop) signal that is picked up by the telecoil of your hearing aid(s) (this option is activated by setting the hearing aid(s) to the “T” or “MT” position).

The CLA7v2 is compatible with most cellular phones (you may need to purchase an adapter connector if your cellular phone is not equipped with a built-in 2.5 mm jack).

The CLA7v2 new universal design now allows for connection to your iPod type device!

FEATURES:

• Powerful 30 dB adjustable gain of amplification
• External amplification control
• Built-in mircophone
• Powered with standard AAA batteries making battery replacement a breeze
• Standard 2.5mm connector
• Lightweight & stylish
• Base Size: 2.5" X 1.25" X .75"
• Weight: 0.12 lb with batteries
• Power Requirements: (2) AAA Alkaline batteries (not included)
• 1 year warranty

Making And Receiving Calls

1. Place the loop around your neck.
2. Connect the 2.5 mm plug of the CLA7v2 into the your telephone’s 2.5 mm headset jack.
3. Switch your hearing aid to “T” or “MT” mode.
4. Press the “ON/OFF” button. The green light will turn on.
5. Use your telephone in a normal way (making and receiving calls). See the phone’s owner’s manual for instructions.
6. Since the CLA7v2 has a built in microphone, you will not need to hold the phone to your ear, but can use it in conjunction with a belt clip. Simply keep the phone in your pocket or placed on a flat surface.
7. During the call, you can adjust the volume of the CLA7 by using the volume control knob located on the bottom of the unit.
8. You can manually adjust the volume level on your phone also.
9. On completion of the call, press the ON/OFF button. The green light will turn off. If you forget to turn “OFF” your CLA7v2 at the end of the call, it will automatically turn “OFF” after a few minutes of inactivity.
10. Reset your hearing aid if needed.

Note: If your phone does not have a 2.5mm jack, an adapter may be required. Check with the manufacturer of the telephone equipment.